| |
|
|
|
| |
 |
| |
| If ornament is not on
pole or if you wish to change ornament |
| |
- Securely grasp the 3-inch metal rod that protrudes from
the bottom of the top half of the pole.
- Screw the ornament onto the top of the pole as far as
it will go, being careful not to cross thread or over tighten.
|
| |
| To assemble top and bottom of pole together |
| |
- Locate dimple in open end of lower section
- Slide 3-inch plastic rod that protrudes from the top
section into the bottom section, lining up L-shaped groove
with dimple in bottom section.
- Press two sections of pole against each other until flush.
CAUTION: Do not jam pole sections together
- Securely grasp the ornament on the top half of the pole
with one hand and the bottom section of pole with the other
hand and GENTLY turn bottom section so that it slides into
the L-shaped groove. Be careful not to over tighten.
- The two sections of the pole should now be locked and
the top half of pole should spin freely.
|
| |
| To Mount Traditional Style Flag (heading
and 2 grommets) on Pole |
| |
- Remove set -screws from flag fasteners, slip first fastener
up bottom of flagpole and position just below swivel clip.
Note: Swivel clip and snap hooks are not used with traditional
style flag.
- Position opening in fastener under the top grommet of
flag.
- Replace set- screw in fastener through grommet of flag
thereby holding flag snug against pole.
- Repeat with lower grommet.
|
| |
| To Mount Banner Style Flag (Pole Sleeve)
on Pole |
| |
- Slide pole through banner sleeve
- Locate pre-slit tab sewn inside top of banner sleeve
- Attach snap hook (on swivel clip) to pre-slit tab. Note:
Flag fasteners are not used with banner style flags.
Caution: Spinning
poles are not to be used with flags heavier than nylon
or larger than 3x5 feet. Flags should not be flown
in extreme wind conditions.
|
| |
| To Disassemble Spinning Pole |
| |
- Hold ornament firmly in one hand and bottom section
of pole in the other hand.
- Line up dimple on bottom section of pole with arrow
on joint.
- Gently pull sections apart. The two sections should
come apart easily.
Caution: Do not use
force. If top and bottom do not separate easily, repeat
step 1 and turn pole slightly in either direction while
pulling gently.
|
| |
 |
| If you have a Complete Set that
Includes the Bracket see below: |
| |
| To Mount Flagpole to Building |
| |
- Mount bracket to building with screws supplied.
- Adjust bracket to desired angle and tighten wing nut
to secure.
- Insert pole into bracket.
- Hand-tighten set screw to secure pole.
|
| |
| Top |
|
| |
|
|
|